,

How to Bypass Factory Reset Protection on YU Yuphoria YU5010A & YU5010

This tutorial shows how to bypass Factory Reset Protection on YU Yuphoria YU5010 & YU5010A

Imagine a situation where you have lost your device and someone got their hands on it and without returning it to you, they thought of keeping it to themselves. In this situation, they will wipe the device’s user data and settings from Recovery Mode to bypass the lock screen protection (PIN or Pattern). But to their surprise, they will see a Google Account Sign In page, where you have to use the same Google Account which was on the device before resetting it. This protection was introduced by Google to prevent thefts and is called Factory Reset Protection (FRP).

How to Bypass Factory Reset Protection on YU Yuphoria YU5010A & YU5010 Unbrick and Install CM 12 on YU Yuphoria YU5010 Unlock Bootloader on YU Yuphoria Factory Hard Reset YU Yuphoria

But there might be some situation where you have Factory Reset your device from Recovery Mode and don’t remember the Google Account password or the account is blocked permanently. In this case, you can follow the below tutorial and bypass the Factory Reset protection on your YU Yuphoria YU5010 or YU5010A.

Disclaimer: This tutorial is for educational purpose only and is not intended for any illegal use. We are not responsible for any misuse of the knowledge shared in this tutorial.

So without any further ado, let’s proceed and see how to bypass Factory Reset Protection on YU Yuphoria YU5010 or YU5010A.

How to Bypass Factory Reset Protection on YU Yuphoria YU5010 & YU5010A:

Step 1: Install YU USB Drivers on your PC from here.

Step 2: Also install and setup ADB and Fastboot Drivers on PC. Make sure to use 15 Seconds installer and install it as system-wide.

Step 3: Boot YU Yuphoria into Fastboot Mode. How? YU5010 (Watch this video); YU5010A follow the instruction below:

  1. Power off the device.
  2. Press and hold Volume Up and Power buttons together until you see Fastboot Mode on Screen.

Step 4: Connect your device to PC using Micro USB Data Cable.

Step 5: Open Command Prompt and enter the below commands:

fastboot –i 0x2A96 erase config
fastboot –i 0x2A96 reboot

Congratulation! Now the Factory Reset Protection or FRP Screen is successfully bypassed on YU Yuphoria YU5010 or YU5010A.

Did this tutorial help you? If yes, then don’t forget to share it on Facebook, Twitter and Google Plus etc.

Have any questions? Feel free to ask them in the comment section below.


Written by

Alpesh

Tech Lover, Gadget Freak and the founder of Gizmo Advices who loves to play with Custom ROM's, Kernel's etc.

Leave a Reply

Your email address will not be published. Required fields are marked *

Human Verification: In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.


Enable Android Instant Apps and Use It

How to Enable Android Instant Apps and Use It!

Disable or Remove New WhatsApp Status Feature on Android

How To Disable or Remove New WhatsApp Status Stories Feature on Android